Configuration
209
Aastra 470 ab R3.0
syd-0337/1.5 – R3.0 – 05.2013
2. Enter the licence code under CM_1.2_Licence code in AMS and save it in the com-
munication server. The licence code is stored on the EIM card.
3. The newly licensed features are enabled. It is not necessary to restart the com-
munication server (exception: AIN licences).
All the features (even those subject to charges) can be configured offline without a
valid licence. During the configuration or during the configuration data upload the
user is warned that the communication server does not yet have the required li-
cence.
Each licence code can only be used for one communication server. If a communica-
tion system consists of several communication servers (e.g. in a AIN), normally only
one licence code is required on the Master.
To licence several communication servers, you will obtain separate licence codes to
match the licence information of the individual communication server.
The licence information can be viewed directly from the communication server us-
ing the Configuration Manager in AMS.
The data stored on the EIM card is not deleted by a first start of the PBX, and re-
mains available.
See also:
"Licences", page 70
Reading out default values
There is a simple method for reading out the country-specific default values:
1. In offline mode on the AMS Shell create a new communication server for the re-
quired sales channel.
2. Log in with the default access data
3. Open Configuration Manager
4. Add the desired hardware in the System configuration.
5. Add system terminals, mailboxes, direct dialling numbers etc.
6. Most default values can now be read out.
CPU2 applications card configuration
The applications card configuration is described in the CPU2 applications card in-
stallation instructions.
To Next Page
Loading...
Need help?
General