ADCMT 6253 - Output Value at Sweep Stop; Reverse Operations in Pulse Sweep Mode

6253 DC Voltage Current Source/Monitor Operation Manual
4.2.3 Operations in Sweep Source Mode
4-25
4.2.3.6 Output Value at Sweep Stop
The output value at sweep stop varies depending on the RTB (Return to Bias) setting.
Table 4-7 Reverse Operations in Pulse Sweep Mode
Operational
condition
Trigger
mode
Operation Remarks
Pulse
sweep
AUTO Th: Hold time
Tp: Period time
Td: Measurement
delay time
Tds: Source delay
time
Tm: Measurement
time
(Integration
time +
Measurement
data processing
time)
Tcn: Operate
processing time
Trc: Range change
processing time
HOLD
RTB Waveform Operational Descriptions
ON
Returns to the bias value when
sweep stops.
OFF
Stays at the stop value when
sweep stops.
Bias value
Base value
Operate
Start trigger
RTB ON
(returns to the bias value)
RTB OFF
(stays at the present value)
Bias value
Base value
Operate
Start trigger
Trigger Trigger Trigger Trigger
Trigger
Trigger
RTB ON
(returns to the bias
value)
RTB OFF
(stays at the present
value)
Start value
Bias value
Stop value
Start value
Bias value
Stop value