6253 DC Voltage Current Source/Monitor Operation Manual
1.4.1 Environmental Conditions
1-6
Figure 1-2 Operating Environment
NOTE: Warm-up time
Allow the 6253 to warm up for at least 60 minutes after turning on the power at room
temperature to ensure the specified accuracy of the 6253.
Vibration
Direct sunlight
Corrosive
gas
Front
• Avoid operation in these areas.
• Use a noise-cut filter when there is a large amount
of noise riding on the power line.
Dust
• Keep the rear panel more than 10 centimeters away
from the wall.
Front
• Do not position the 6253 with the rear panel
facing down.
Line Filter
To Next Page
Loading...
