2D-LC User Guide 101
4Installation
Software Installation
3 To improve the data rate for each detector, it is recommended to connect
both,
1
D and
2
D, detectors to the LAN. To configure the second detector for
the LAN communication, you have to select the detector in the UI and click
Additional connection.... Then type in the second LAN address and check Use
auxiliary connection.
Figure 48 Set up another LAN Connection for the second detector
4 When configuration is completed, click OK.
For a well-functioning 2D-LC system with two detectors, you need an extra
device like a hub or a switch or at least a second LAN card in your PC.
To Next Page
Loading...
