Agilent Technologies 8563E User Manual

692 Chapter9
If You Have a Problem
Error Messages
Error codes 200 through 299 relate to ADC hardware/firmware
failures. Instrument service is required.
ERR 200 SYSTEM ADC Driver/ADC hardware/firmware interaction;
check for other errors.
ERR 201 SYSTEM ADC Controller/ADC hardware/firmware
interaction; check for other errors.
ERR 202 FADC CAL Linear offset search failed.
This error applies applies only to EC-series analyzers
and E-series analyzers with fast ADC (Option 007)
ERR 203 FADC CAL Log offset search failed.
This error applies applies only to EC-series analyzers
and E-series analyzers with fast ADC (Option 007)
ERR 204 FADC CAL Log 2× expand offset search failed.
This error applies applies only to EC-series analyzers
and E-series analyzers with fast ADC (Option 007)
ERR 205 FADC CAL Linear slope calibration is out of range.
This error applies applies only to EC-series analyzers
and E-series analyzers with fast ADC (Option 007)
ERR 206 FADC CAL Log slope calibration is out of range.
This error applies applies only to EC-series analyzers
and E-series analyzers with fast ADC (Option 007)
ERR 207 FADC CAL Log 2× expand slope calibration is out of range.
This error applies applies only to EC-series analyzers
and E-series analyzers with fast ADC (Option 007)
ERR 250 OUTOF RG ADC input is outside of ADC range.
ERR 251 NO IRQ Microprocessor not receiving interrupt from ADC.

Agilent Technologies 8563E Specifications

General

Brand	Agilent Technologies
Model	8563E
Category	Measuring Instruments
Language	English