G4208A User’s Guide 137
5 Maintenance and Repair
Firmware Updates
The installation of older firmware might be necessary:
• to keep all systems on the same (validated) revision, or
• if third- party control software requires a special version.
To upgrade/downgrade the firmware,
1 Download the firmware and the documentation from the Agilent web
http://www.agilent.com/en-us/firmwareDownload?whid=69761
2 Load the firmware into the module(s) as described in “Updating the Firmware
Using The Single Mode” on page 138 or “Updating the Firmware Using The
Wizard” on page 140.
Table 13 Firmware Update Tools
Update via Module Instant Pilot G4208A LAN/RS-232 Update Tool
2.10 and a PC with LAN or
RS-232
Lab Advisor B.02.06 and
above and a PC with
LAN/RS-232/USB
Instant Pilot G4208A USB Flash Drive via the HPLC system plus
CAN
via the HPLC system plus
CAN
1100/1200/1260/1290 HPLC
Modules
USB Flash Drive plus CAN
cable
requires LAN / RS-232 plus
CAN cable
requires LAN / RS-232/USB
plus CAN cable
Use one of the above mentioned update tools, see Table 13 on page 137. The
tools are also available via the above-mentioned Agilent web.
If the Instant Pilot is in “Backward compatible mode ON”, see “With 3rd Party
Control Software” on page 106, it will not be seen by the Firmware Update Tool.
In this case reconfigure the Instant Pilot to “Backward compatible mode OFF”.
To Next Page
Loading...
Need help?
General
