G4208A User’s Guide 148
5 Maintenance and Repair
Firmware Updates
Upgrade from A.05.11 to A.05.1x
If the Instant Pilot needs to be updated with a new firmware revision , follow
these steps:
1 Disconnect all 1100/1200 series module from that module that hosts the
LAN/RS- 232 interface.
2 Upgrade this module to firmware A.06.xx first (otherwise the Instant Pilot is
not visible in the LAN/RS- 232 Update Tool 2.10).
3 After boot, enter the Maintenance screen and press the Controller button.
4 Press the Transfer button.
The Instant Pilot will switch into resident mode (black screen) and the Update
Tool lists now the Instant Pilot.
5 Select the Instant Pilot for update to the target firmware revision
6 Start the update.
7 After boot of the Instant Pilot,
• the Instant Pilot shows “Scanning System ...”
• the LAN/RS- 232 Update Tool 2.10 indicates “100% updated” but does not
display the result dialog.
8 Press Cancel (red cross button) on the LAN/RS- 232 Update Tool 2.10 to stop
the Update process.
The Instant Pilot is no longer listed in the tree view of the Update Tool.
9 Downgrade the 1100/1200 module to the target firmware (A.05.11/13 or
A.05.09/10).
10 When finished,
• the LAN/RS- 232 Update Tool 2.10 shows all 1100/1200 modules without
the Instant Pilot.
• the Instant Pilot shows all modules of the system in the Welcome screen.
11 Close the connection and the LAN/RS- 232 Update Tool 2.10.
To Next Page
Loading...
Need help?
General
