G4208A User’s Guide 93
2 Working with the Instant Pilot
Sequence - Automating Analyses
Press Status to display the actual system status.
If any activities before the system ready (gray status) are still required, press
Continue and all actions (e.g. required lamps are turned on) are performed
automatically.
Figure 68 Sequence - Get Ready screen
When all Get Ready activities are complete
• the system status changes to green,
• the sequence starts immediately and
• the last screen shows up.
Press Status to display the actual system status.
Yellow status indicates a not
ready condition
Exit this screen
Continues will start all activities
automatically to get the system
ready
Current actions are displayed
To Next Page
Loading...
Need help?
General
