Agilent Technologies X Series User Manual

Agilent X-Series Signal Generators User’s Guide 7
Signal Generator Overview
Front Panel Overview
8. Trigger
When trigger mode is set to Trigger Key, this hardkey initiates an immediate trigger event for a
function such as a list or step sweep.
9. Local Cancel/(Esc)
This hardkey deactivates remote operation and returns the signal generator to front panel control,
cancels an active function entry, and cancels long operations (such an IQ calibration).
10. Help
Use this key to display a description of any hardkey or softkey. See “Viewing Key Descriptions” on
page 44.
11. Preset and User Preset
These hardkeys set the signal generator to a known state (factory or user–defined). See “Presetting
the Signal Generator” on page 44.
12. RF Output (N5171B, N5172B, N5181B, N5182B)
12. RF Output (N5173B, N5183B)
13. RF On/Off and LED
This hardkey toggles the operating state of the RF signal present at the RF OUTPUT connector. The
RF On/Off LED lights when RF output is enabled.
14. Mod On/Off and LED
This hardkey enables or disables the modulation of the output carrier signal by an active modulation
format. This hardkey does not set up or activate a format (see “Modulating the Carrier Signal” on
page 59).
The MOD ON/OFF LED lights when modulation of the output is enabled.
Connector Standard:
Option 1EM:
Impedance:
female Type–N
Rear panel output
50 Ω
Damage Levels 50 Vdc, 2 W maximum RF power
Connector Option 513/520:
Option 532/540:
Option 1ED
Option 1EM:
Impedance:
male Pecision APC- 3.5
male Precision 2.4 mm
female Type–N
Rear panel output
50 Ω
Damage Levels 0 Vdc, 0.5 W maximum RF power

Agilent Technologies X Series Specifications

General

Brand	Agilent Technologies
Model	X Series
Category	Portable Generator
Language	English