Agilent Technologies X Series - Page 340

326 Agilent X-Series Signal Generators User’s Guide
Custom Digital Modulation (Option 431)
Creating and Using Bit Files
Figure 13-10 Bit File Display
NOTE When you create new file, the default name appears as UNTITLED, or UNTITLED1, and so
forth. This prevents overwriting previous files.
Entering Bit Values
Bit data is entered into the table editor in 1- bit format. The current hexadecimal value of the binary
data is shown in the Hex Data column, and the cursor position (in hexadecimal) is shown in the
Position indicator.
1. Refer to the following figure.
2. Enter the 32 bit values shown.
Offset
(in Hex)
Bit Data
Cursor Position Indicator
(in Hex)
Hexadecimal Data
File Name Indicator