Alcatel-Lucent 7210 SAS M - Page 190

Configuring a VLL Service with CLI
Page 190 7210 SAS M Services Guide
The following example displays the command usage to bind an Epipe service between ALA-1 and
ALA-2. This example assumes the SAPs have already been configured (see Distributed Epipe
Service on page 184).
A:ALA-1>config>service# epipe 5500
config>service>epipe# spoke-sdp 2:123
config>service>epipe>spoke-sdp# egress
config>service>epipe>spoke-sdp>egress# vc-label 5500
config>service>epipe>spoke-sdp>egress# exit
config>service>epipe>spoke-sdp# ingress
config>service>epipe>spoke-sdp>ingress# vc-label 6600
config>service>epipe>spoke-sdp>ingress# exit
config>service>epipe>spoke-sdp# no shutdown
ALA-2>config>service# epipe 5500
config>service>epipe# spoke-sdp 2:456
config>service>epipe>spoke-sdp# egress
config>service>epipe>spoke-sdp>egress# vc-label 6600
config>service>epipe>spoke-sdp>egress# exit
config>service>epipe>spoke-sdp# ingress
config>service>epipe>spoke-sdp>ingress# vc-label 5500
config>service>epipe>spoke-sdp>ingress# exit
config>service>epipe>spoke-sdp# no shutdown
This example displays the SDP binding for the Epipe service between ALA-1 and ALA-2:
A:ALA-1>config>service# info
----------------------------------------------
...
epipe 5500 customer 5 vpn 5500 create
description "Distributed epipe service to east coast"
sap 1/1/3:21 create
ingress
qos 555
filter ip 1
exit
exit
spoke-sdp 2:123 create
ingress
vc-label 6600
exit
egress
vc-label 5500
exit
exit
no shutdown
exit
...
----------------------------------------------
A:ALA-1>config>service#
A:ALA-2>config>service# info
----------------------------------------------
...
exit
epipe 5500 customer 5 vpn 5500 create
description "Distributed epipe service to west coast"