VPLS Features
Page 280 7210 SAS M Services Guide
The flush-mine message is generated under following conditions:
• The flush-mine message is received from LDP peer and “propagate-mac-flush” flag is
enabled. The message is sent to all LDP peers in the context of VPLS service it was
received.
• The flush-mine message is generated when on a SAP or SDP transition from operationally
up to an operationally down state and send-flush-on-failure flag is enabled in the context
of the given VPLS service. The message is sent to all LDP peers connected in the context
of the given VPLS service. Note, that enabling “send-flush-on-failure” the flag is blocked
in VPLS service managed by mVPLS. This is to prevent that both messages are sent at the
same time.
• The flush-mine message is generated when on a MC-LAG SAP or MC-APS SAP
transition from an operationally up state to an operationally down state. The message is
sent to all LDP peers connected in the context of the given VPLS service.
• The flush-mine message is generated when on a MC-RING SAP transition from
operationally up to an operationally down state or when MC-RING SAP transitions to
slave state. The message is sent to all LDP peers connected in the context of the given
VPLS service.
To Next Page
Loading...
