Virtual Private LAN Services
Page 376 7210 SAS M Services Guide
customer customer-id — Specifies the customer ID number to be associated with the service. This
parameter is required on service creation and optional for service editing or deleting.
Values 1 — 2147483647
vpls vpn
m-vpls — Specifies a management VPLS.
create — This keyword is mandatory while creating a VPLS service.
customer-vid vlan-id — Defines the dot1q VLAN ID to be specified while creating the local Dot1q
SAP for svc-sap-type dot1q-preserve.
Values 1 — 4094
dot1q-preserve — Specifies that the allowed SAP in the service are Dot1q. The Dot1q ID is not
stripped after packets matches the SAP.
Default null-star
null-star — Specifies that the allowed SAP in the service which can be Null SAP,dot1q Default
SAP,Q.* SAP or Default QinQ SAP.
svc-sap-type-Specifies the type of service and allowed SAPs in the service.
bgp
Syntax bgp
Context config>service>vpls
This command enables the context to configure the BGP related parameters to BGP AD.
block-on-mesh-failure
Syntax [no] block-on-mesh-failure
Context config>service>vpls>spoke-sdp
config>service>vpls>endpoint
Description This command enables blocking (brings the entity to an opererationally down state) after all
configured SDPs or endpoints are in opererationally down state. This event is signalled to
corresponding T-LDP peer by withdrawing service label (status-bit-signaling non-capable peer) or by
setting “PW not forwarding” status bit in T-LDP message (status-bit-signaling capable peer).
Default disabled
bpdu-translation
Syntax bpdu-translation {auto | pvst | stp}
no bpdu-translation
Context config>service>vpls>spoke-sdp
To Next Page
Loading...
Need help?
General
