Virtual Private LAN Services
7210 SAS M Services Guide Page 387
Context config>service>vpls
Description This command specifies the multicast FIB high watermark. When the percentage filling level of the
multicast FIB exceeds the configured value, a trap is generated and/or a log entry is added.
Parameters high-water-mark — Specifies the multicast FIB high watermark as a percentage.
Values 1 — 100
Default 95%
mfib-table-low-wmark
Syntax [no] mfib-table-low-wmark low-water-mark
Context config>service>vpls
Description This command specifies the multicast FIB low watermark. When the percentage filling level of the
Multicast FIB drops below the configured value, the corresponding trap is cleared and/or a log entry
is added.
Parameters low-water-mark — Specifies the multicast FIB low watermark as a percentage.
Values 1 — 100
Default 90%
mfib-table-size
Syntax mfib-table-size size
no mfib-table-size
Context config>service>vpls
Description This command specifies the maximum number of (s,g) entries in the multicast forwarding database
(MFIB) for this VPLS instance.
The mfib-table-size parameter specifies the maximum number of multicast database entries for both
learned and static multicast addresses for the VPLS instance. When a table-size limit is set on the
mfib of a service which is lower than the current number of dynamic entries present in the mfib then
the number of entries remains above the limit.
The no form of this command removes the configured maxium MFIB table size.
Default none
Parameters size — The maximum number of (s,g) entries allowed in the Multicast FIB.
remote-age
Syntax remote-age seconds
no remote-age
To Next Page
Loading...
Need help?
General
