VPLS Service Commands
7210 SAS M Services Guide Page 463
vpn
customer-vid vlan-id — Defines the dot1q VLAN ID to be specified while creating the local Dot1q
SAP for svc-sap-type dot1q-preserve.
Values 1 — 4094
dot1q — Specifies that the allowed SAP in the service are Dot1q SAPs and dot1q explicit null SAPs.
dot1q-preserve — Specifies that the allowed SAP in the service are Dot1q. The Dot1q ID is not
stripped after packet matches the SAP.
null-star — Specifies that the allowed SAP in the service are either null SAPs or Dot1q default
SAPs.
pbb-epipe — keyword used to create a pbb-epipe.
svc-sap-type — Specifies the type of service and allowed SAPs in the service.
vpn vpn-id — Specifies the VPN ID number which allows you to identify virtual private networks
(VPNs) by a VPN ID. If this parameter is not specified, the VPN ID uses the same service ID
number.
Values 1 — 2147483647
Default null (0)
pbb-tunnel
Syntax pbb-tunnel service-id backbone-dest-mac {mac-name | ieee-mac} isid ISID
no pbb-tunnel
Context config>service>epipe
Description This command configures a Provider Backbone Bridging (PBB) tunnel with Backbone VPLS (B-
VPLS) service information.
Parameters service-id — Specifies the B-VPLS service for the PBB tunnel associated with this service.
Values 1 — 2147483648
backbone-dest-mac {mac-name | ieee-mac} — Specifies the backbone destination MAC-address
for PBB packets.
isid ISID — Specifies a 24 bit service instance identifier for the PBB tunnel associated with this
service. As part of the PBB frames, it is used at the destination PE as a demultiplexor field.
Values 0 — 16777215
To Next Page
Loading...
