Alcatel-Lucent 7210 SAS M - Page 466

Show Commands
Page 466 7210-SAS M Services Guide
lag keyword
id 1 — 200
sdp-id[:vc-id] — Specfies an existing SDP and VC ID.
Values 1 — 17407
qtag — Specifies the qtag value.
Values 0 — 4094
level — Specifies the level.
Values 0 — 7
direction up | down — Indicates the direction in which the maintenance association (MEP or MIP)
faces on the bridge port.
down — Displays continuity check information configured away from the MAC relay entity.
up — Displays continuity check information configured toward the MAC relay entity.
service-id — Specifies information about the specified service ID.
Values 1 — 2147483648
Sample Output
*A:alcag1-R6# show eth-cfm cfm-stack-table
========================================================================
CFM SAP Stack Table
========================================================================
Sap Level Dir Md-index Ma-index Mep-id Mac-address
------------------------------------------------------------------------
1/2/9:5 4 Up 1 1 51 00:ae:ae:ae:ae:ae
========================================================================
CFM SDP Stack Table
========================================================================
Sdp Level Dir Md-index Ma-index Mep-id Mac-address
------------------------------------------------------------------------
No Matching Entries
========================================================================
*A:alcag1-R6#
domain
Syntax domain [md-index] [association ma-index | all-associations [detail]]
Context show>eth-cfm>domain
Description This command displays domain information.
Parameters md-index — Specifies the maintenance domain (MD) index value.
Values 1 — 4294967295
ma-index — Specifies the MA index value.
Values 1 — 4294967295
all-associations — Displays information all maintenance associations.