IES Global Commands
Page 530 7210-SAS M Services Guide
Description This command specifies whether “packet-too-big” ICMPv6 messages should be sent. When enabled,
ICMPv6 “packet-too-big” messages are generated by this interface.
The no form of the command disables the sending of ICMPv6 “packet-too-big” messages.
Default 100 10
Parameters number — Specifies the number of “packet-too-big” ICMPv6 messages to send in the time frame
specified by the seconds parameter.
Values 10 — 1000
Default 100
seconds — Specifies the time frame in seconds that is used to limit the number of “packet-too-big”
ICMPv6 messages issued.
Values 1 — 60
Default 10
param-problem
Syntax param-problem [number seconds]
no packet-too-big
Context config>service>ies>if>ipv6>icmp6
Description This command specifies whether “parameter-problem” ICMPv6 messages should be sent. When
enabled', “parameter-problem” ICMPv6 messages are generated by this interface.
The no form of the command disables the sending of “parameter-problem” ICMPv6 messages.
Default 100 10
number — Specifies the number of “parameter-problem” ICMPv6 messages to send in the time
frame specified by the seconds parameter.
Values 10 — 1000
Default 100
seconds — Specifies the time frame in seconds that is used to limit the number of “parameter-
problem” ICMPv6 messages issued.
Values 1 — 60
Default 10
redirects
Syntax redirects [number seconds]
no redirects
Context config>service>ies>if>ipv6>icmp6
To Next Page
Loading...
