IES Service Configuration Commands
7210-SAS M Services Guide Page 531
Description This command configures ICMPv6 redirect messages. When enabled, ICMPv6 redirects are
generated when routes are not optimal on this router and another router on the same subnetwork has a
better route in order to alert that node that a better route is available.
When disabled, ICMPv6 redirects are not generated.
Default 100 10
number — Specifies the number of version 6 redirects are to be issued in the time frame specified by
the seconds parameter.
Values 10 — 1000
Default 100
seconds — Specifies the time frame in seconds that is used to limit the number of version 6 redirects
issued.
Values 1 — 60
Default 10
time-exceeded
Syntax time-exceeded [number seconds]
no time-exceeded
Context config>service>ies>if>ipv6>icmp6
Description This command specifies whether “time-exceeded” ICMPv6 messages should be sent. When enabled,
ICMPv6 “time-exceeded” messages are generated by this interface.
When disabled, ICMPv6 “time-exceeded” messages are not sent.
Default 100 10
number — Specifies the number of “time-exceeded” ICMPv6 messages are to be issued in the time
frame specified by the seconds parameter.
Values 10 — 1000
Default 100
seconds — Specifies the time frame in seconds that is used to limit the number of “time-exceeded”
ICMPv6 message to be issued.
Values 1 — 60
Default 10
unreachables
Syntax unreachables [number seconds]
no unreachables
Context config>service>ies>if>ipv6>icmp6
To Next Page
Loading...
Need help?
General
