IES Global Commands
Page 532 7210-SAS M Services Guide
Description This command specifies that ICMPv6 host and network unreachable messages are generated by this
interface.
When disabled, ICMPv6 host and network unreachable messages are not sent.
Default 100 10
number — Specifies the number of destination unreachable ICMPv6 messages are issued in the time
frame specified by the seconds parameter.
Values 10 — 1000
Default 100
seconds — Specifies the time frame in seconds that is used to limit the number of destination
unreachable ICMPv6 messages to be issued.
Values 1 — 60
Default 10
link-local-address
Syntax link-local-address ipv6-address [preferred]
no link-local-address
Context config>service>ies>if>ipv6
Description This command configures the IPv6 link local address.
local-proxy-nd
Syntax [no] local-proxy-nd
Context config>service>ies>if>ipv6
Description This command enables local proxy neighbor discovery on the interface.
The no form of the command disables local proxy neighbor discovery.
proxy-nd-policy
Syntax proxy-nd-policy policy-name [policy-name...(up to 5 max)]
no proxy-nd-policy
Context config>service>ies>if>ipv6
Description This command applies a proxy neighbor discovery policy for the interface.
Parameters policy-name — Specifies an existing neighbor discovery policy name. Allowed values are any string
up to 32 characters long composed of printable, 7-bit ASCII characters. If the string contains
To Next Page
Loading...
Need help?
General
