IES Service Configuration Commands
7210-SAS M Services Guide Page 541
no v4-routed-override-filter
Context config>service>ies>if>vpls>ingress
Description The v4-routed-override-filter command is used to specify an IP filter ID that is applied to all ingress
packets entering the VPLS service. The filter overrides any existing ingress IP filter applied to SAPs
or SDP bindings for packets associated with the routing IP interface. The override filter is optional
and when it is not defined or it is removed, the IP routed packets uses the any existing ingress IP filter
on the VPLS virtual port.
The no form of the command is used to remove the IP routed override filter from the ingress IP
interface. When removed, the IP ingress routed packets within a VPLS service attached to the IP
interface uses the IP ingress filter applied to the packets virtual port when defined.
Default none
Parameters ip-filter-id — Specifies the ID for the IP filter policy. Allowed values are an integer in the range of 1
and 65535 that corresponds to a previously created IP filter policy in the configure>filter>ip-
filter context.
Values 1 — 65535
To Next Page
Loading...
Need help?
General
