Alcatel-Lucent 7210 SAS M - Page 575

Virtual Private Routed Network Services
7210 SAS M Services Guide Page 575
Configuring a VPRN Interface SAP
VPRN Interface SAP
VPRN interfac e
A SAP is a combination of a port and encapsulation parameters which identifies the service access
point on the interface and within the 7210 SAS. Each SAP must be unique within a router. A SAP
cannot be defined if the interface loopback command is enabled.
When configuring VPRN interface SAP parameters, a default QoS policy is applied to each
ingress and egress SAP. Additional QoS policies and scheduler policies must be configured in the
config>qos context. Filter policies are configured in the config>filter context and must be
explicitly applied to a SAP. There are no default filter policies.
The following example displays a VPRN interface SAP configuration:
*A:ALA-1>config>service# info
----------------------------------------------
...
vprn 1 customer 1 create
vrf-import "vrfImpPolCust1"
vrf-export "vrfExpPolCust1"
autonomous-system 10000
route-distinguisher 10001:1
auto-bind ldp
vrf-target target:10001:1
interface "to-ce1" create
address 11.1.0.1/24
sap 1/1/10:1 create
ingress
qos 100
exit
egress
qos 1010
filter ip 6
exit
exit
exit
static-route 6.5.0.0/24 next-hop 10.1.1.2
spoke-sdp 2 create
exit
no shutdown
exit
...
----------------------------------------------
*A:ALA-1>config>service#