Virtual Private Routed Network Services
7210 SAS M Services Guide Page 617
by indicating the maximum number of redirect messages that can be issued on the interface for a
given time interval.
By default, generation of ICMP redirect messages is enabled at a maximum rate of 100 per 10 second
time interval.
The no form of this command disables the generation of icmp redirects on the router interface.
Default redirects 100 10 — Maximum of 100 redirect messages in 10 seconds.
Parameters number — The maximum number of ICMP redirect messages to send. This parameter must be
specified with the seconds parameter.
Values 10 — 1000
seconds — The time frame in seconds used to limit the seconds of ICMP redirect messages that can
be issued.
Values 1 — 60
ttl-expired
Syntax ttl-expired number seconds
no ttl-expired
Context config>service>vprn>if>icmp
config>service>vprn>sub-if>grp-if>icmp
config>service>vprn>nw-if>icmp#
Description Configures the rate Internet Control Message Protocol (ICMP) TTL expired messages are issued by
the IP interface.
By default, generation of ICMP TTL expired messages is enabled at a maximum rate of 100 per 10
second time interval.
The no form of this command disables the limiting the rate of TTL expired messages on the router
interface.
Default ttl-expired 100 10
Parameters number — The maximum number of ICMP TTL expired messages to send, expressed as a decimal
integer. This parameter must be specified with the seconds parameter.
Values 10 — 1000
seconds — The time frame in seconds used to limit the number of ICMP TTL expired messages that
can be issued, expressed as a decimal integer.
Values 1 — 60
To Next Page
Loading...
