Alcatel-Lucent 7210 SAS M - Page 620

VPRN Service Configuration Commands
Page 620 7210 SAS M Services Guide
The port-id must reference a valid port type. When the port-id parameter represents SONET/
SDH and TDM channels the port ID must include the channel ID. A period “.” separates the
physical port from the channel-id. The port must be configured as an access port.
If the SONET/SDH port is configured as clear-channel then only the port is specified.
create — Keyword used to create a SAP instance.
split-horizon-group group-name — Specifies the name of the split horizon group to which the SAP
belongs.
tod-suite
Syntax tod-suite tod-suite-name
no tod-suite
Context config>service>vprn>if>sap
Description This command applies a time-based policy (filter or QoS policy) to the SAP. The suite name must
already exist in the config>cron context.
Default no tod-suite
Parameters tod-suite-name — Specifies collection of policies (ACLs, QoS) including time-ranges that define the
full or partial behavior of a SAP or a subscriber. The suite can be applied to more than one SAP.
accounting-policy
Syntax accounting-policy acct-policy-id
no accounting-policy
Context config>service>vprn>if>sap
Description This command creates the accounting policy context that can be applied to an interface SAP or
interface SAP spoke SDP.
An accounting policy must be defined before it can be associated with a SAP.
If the policy-id does not exist, an error message is generated.
A maximum of one accounting policy can be associated with a SAP at one time. Accounting policies
are configured in the config>log context.
The no form of this command removes the accounting policy association from the SAP, and the
acccounting policy reverts to the default.
Default Default accounting policy.
Parameters acct-policy-id — Enter the accounting policy-id as configured in the config>log>accounting-policy
context.
Values 1 — 99