Virtual Private Routed Network Services
7210 SAS M Services Guide Page 639
accepted number of groups, the groups that are already accepted are not deleted. Only new groups
will not be allowed. When this object has a value of 0, there is no limit to the number of groups.
Parameters value — Specifies the maximum number of groups for this interface.
Values 1 — 16000
multicast-senders
Syntax multicast-senders {auto | always | never}
no multicast-senders
Context config>service>vprn>pim>if
Description This command configures the way subnet matching is done for incoming data packets on this
interface. An IP multicast sender is an user entity to be authenticated in a receiving host.
Parameters auto — Subnet matching is automatically performed for incoming data packets on this interface.
always — Subnet matching is always performed for incoming data packets on this interface.
never — Subnet matching is never performed for incoming data packets on this interface.
priority
Syntax priority dr-priority
no priority
Context config>service>vprn>pim>if
Description This command sets the priority value to become the rendezvous point (RP) that is included in
bootstrap messages sent by the router. The RP is sometimes called the bootstrap router.
The priority command indicates whether the router is eligible to be a bootstrap router.
The no form of the command disqualifies the router to participate in the bootstrap election.
Default 1 (The router is the least likely to become the designated router.)
Parameters dr-priority — Specifies the priority to become the designated router. The higher the value, the higher
the priority.
Values 1 — 4294967295
To Next Page
Loading...
Need help?
General
