VPRN Service Configuration Commands
Page 662 7210 SAS M Services Guide
Parameters ipv4 — Provisions IPv4 support.
group
Syntax group name [dynamic-peer]
no group
Context config>service>vprn>bgp
Description This command creates a context to configure a BGP peer group.
The no form of the command deletes the specified peer group and all configurations associated with
the peer group. The group must be shutdown before it can be deleted.
Default None — No peer groups are defined.
Parameters name — The peer group name. Allowed values is a string up to 32 characters long composed of
printable, 7-bit ASCII characters. If the string contains special characters (#, $, spaces, etc.), the
entire string must be enclosed within double quotes.
dynamic-peer — This flag designates that the given BGP group will be used by BGP peers created
dynamically based on subscriber-hosts pointing to corresponding BGP peering policy. There can
be only one BGP group with this flag set in any given VPRN. No bBGP neighbous can be
manually configured in a BGP group with this flag set.
Default disabled
neighbor
Syntax [no] neighbor ip-address
Context config>service>vprn>bgp>group
Description This command creates a BGP peer/neighbor instance within the context of the BGP group.
This command can be issued repeatedly to create multiple peers and their associated configuration.
The no form of the command is used to remove the specified neighbor and the entire configuration
associated with the neighbor. The neighbor must be administratively shutdown before attempting to
delete it. If the neighbor is not shutdown, the command will not result in any action except a warning
message on the console indicating that neighbor is still administratively up.
Default none — No neighbors are defined.
Parameters ip-address — The IP address of the BGP peer router in dotted decimal notation.
Values ipv4-address : a.b.c.d
To Next Page
Loading...
Need help?
General
