Show, Clear, Debug Commands
Page 676 7210 SAS M Services Guide
Services Show Commands
Service Commands
customer
Syntax customer [customer-id] [site customer-site-name]]
Context show>service
Description This command displays service customer information.
Parameters customer-id — Displays only information for the specified customer ID.
Default All customer IDs display.
Values 1 — 2147483647
site customer-site-name — Specifies the customer site which is an anchor point for an ingress and egress
virtual scheduler hierarchy.
Output Show Customer Command Output — The following table describes show customer command output
fields:
Label Description
Customer-ID The ID that uniquely identifies a customer.
Contact The name of the primary contact person.
Description Generic information about the customer.
Phone The phone/pager number to reach the primary contact person.
Total Customers The total number of customers configured.
Site Multi-service site name. A multi-service customer site is a group of SAPs
with common origination and termination points.
Description Displays information about a specific customer's multi-service site.
Assignment The port ID, MDA, or card number, where the SAP's that are members of
this multi- service site are defined.
I. Sched Pol The ingress QoS scheduler policy assigned to this multi-service site.
E. Sched Pol The egress QoS scheduler policy assigned to this multi-service site.
Service-ID The ID that uniquely identifies a service.
SAP Specifies the SAP assigned to the service.
To Next Page
Loading...
