Show, Clear, Debug Commands
Page 682 7210 SAS M Services Guide
Sample Output
*A:ALA-7210M# show service sdp
==============================================================================
Services: Service Destination Points
==============================================================================
SdpId Adm MTU Opr MTU IP address Adm Opr Deliver Signal
------------------------------------------------------------------------------
10 4462 4462 10.20.1.3 Up Dn NotReady MPLS TLDP
40 4462 1534 10.20.1.20 Up Up MPLS TLDP
60 4462 1514 10.20.1.21 Up Up MPLS TLDP
100 4462 4462 180.0.0.2 Down Down MPLS TLDP
500 4462 4462 10.20.1.50 Up Dn NotReady MPLS TLDP
------------------------------------------------------------------------------
Number of SDPs : 5
==============================================================================
*A:ALA-7210M#
sdp-using
Syntax sdp-using [sdp-id[:vc-id] | far-end ip-address]
Context show>service
Description This command displays services using SDP or far-end address options.
Parameters sdp-id — Displays only services bound to the specified SDP ID.
Values 1 — 17407
Class Forwarding
Indicates the admin state of class-based forwarding on this SDP. When the
value is true, class-based forwarding is enabled.
EnforceDSTELspFc
Specifies whether service manager must validate with RSVP the support of
the FC by the LSP.
Default LSP
Specifies the LSP ID that is used as a default when class-based forwarding is
enabled on this SDP. This object must be set when enabling class-based for-
warding.
Multicast LSP
Displays the LSP ID that all multicast traffic will be forwarded on when
class-based forwarding is enabled on this SDP. When this object has its
default value, multicast traffic will be forwarded on an LSP according to its
forwarding class mapping.
Number of SDPs
The total number of SDPs displayed according to the criteria specified.
Label Description (Continued)