Show, Clear, Debug Commands
Page 728 7210-SAS M Services Guide
service-using
Syntax service-using [epipe] [ies] [vpls] [vprn][sdp sdp-id] [customer customer-id]
Context show>service
Description Displays the services matching certain usage properties.
If no optional parameters are specified, all services defined on the system are displayed.
Parameters epipe — Displays matching Epipe services.
ies — Displays matching IES instances.
vpls — Displays matching VPLS instances.
vprn — Displays matching VPRN services.
sdp sdp-id — Displays only services bound to the specified SDP ID.
Default Services bound to any SDP ID.
Values 1 — 17407
customer customer-id — Displays services only associated with the specified customer ID.
Default Services associated with an customer.
Values 1 — 2147483647
Output Show Service Service-Using — The following table describes show service service-using output
fields:
Sample Output
*A:ALA-12# show service service-using customer 10
==============================================================================
Services
==============================================================================
ServiceId Type Adm Opr CustomerId Last Mgmt Change
------------------------------------------------------------------------------
1 VPLS Up Up 10 09/05/2006 13:24:15
100 IES Up Up 10 09/05/2006 13:24:15
Label Description
Service Id
The service identifier.
Type
Specifies the service type configured for the service ID.
Adm
The desired state of the service.
Opr
The operating state of the service.
CustomerID
The ID of the customer who owns this service.
Last Mgmt Change
The date and time of the most recent management-initiated change to
this service.