VPRN Show Commands
7210-SAS M Services Guide Page 749
sdp
Syntax sdp [sdp-id | far-end ip-addr] [detail]
Context show>service>id
Description Displays information for the SDPs associated with the service. If no optional parameters are
specified, a summary of all associated SDPs is displayed.
Parameters sdp-id — Displays only information for the specified SDP ID.
Default All SDPs.
Values 1 — 17407
far-end ip-addr — Displays only SDPs matching with the specified far-end IP address.
Default SDPs with any far-end IP address.
detail — Displays detailed SDP information.
Output Show Service-ID SDP — The following table describes show service-id SDP output fields:
Label Description
Sdp Id
The SDP identifier.
Type
Indicates whether the SDP is a spoke or a mesh.
Split Horizon
Group
Name of the split horizon group that the SDP belongs to.
VC Type
Displays the VC type: ether or vlan.
VC Tag
Displays the explicit dot1Q value used when encapsulating to the SDP
far end.
I. Lbl
The VC label used by the far-end device to send packets to this device
in this service by the SDP.
Admin Path MTU
The operating path MTU of the SDP is equal to the admin path MTU
(when one is set) or the dynamically computed tunnel MTU, when no
admin path MTU is set (the default case.)
Oper Path MTU
The actual largest service frame size (in octets) that can be transmitted
through this SDP to the far-end router, without requiring the packet to
be fragmented.
Far End
Specifies the IP address of the remote end of the GRE or MPLS tunnel
defined by this SDP.
Delivery
Specifies the type of delivery used by the SDP: GRE or MPLS.
Admin State
The administrative state of this SDP.
Oper State
The operational state of this SDP.
Ingress Label
The label used by the far-end device to send packets to this device in
this service by this SDP.