Alcatel-Lucent 7210 SAS M - Page 753

VPRN Show Commands
7210-SAS M Services Guide Page 753
Context show>router
Description This command displays aggregated routes.
Parameters active — This keyword filters out inactive aggregates.
Output Show Aggregate Output Fields — The following table describes router aggregate output fields.
Sample Output
*A:ALA-12# show router 3 aggregate
==============================================================================
Aggregates (Service: 3)
==============================================================================
Prefix Summary AS Set Aggr AS Aggr IP-Address State
------------------------------------------------------------------------------
------------------------------------------------------------------------------
No. of Aggregates: 0
-----------------------------------------------------------
*A:ALA-12#
arp
Syntax arp [ip-address | ip-int-name | mac ieee-mac-addr]
Context show>router
Description This command displays the router ARP table sorted by IP address.
If no command line options are specified, all ARP entries are displayed.
Parameters ip-addr — Only displays ARP entries associated with the specified IP address.
ip-int-name — Only displays ARP entries associated with the specified IP interface name.
mac ieee-mac-addr — Only displays ARP entries associated with the specified MAC address.
Label Description
Prefix
Displays the destination address of the aggregate route in dotted
decimal notation.
Summary
Specifies whether the aggregate or more specific components are
advertised.
AS Set
Displays an aggregate where the path advertised for the route con-
sists of all elements contained in all paths that are being summarized.
Aggr AS
Displays the aggregator path attribute to the aggregate route.
Aggr IP-Address
The IP address of the aggregated route.
State
The operational state of the aggregated route.
No. of Aggregates
The total number of aggregated routes.