Show, Clear, Debug Commands
Page 756 7210-SAS M Services Guide
damping
Syntax damping [ip-prefix/mask | ip-address] [detail]
damping [damp-type] [detail]
Context show>router>bgp
Description This command displays BGP routes with have been dampened due to route flapping. This command
can be entered with or without a route parameter.
When the keyword detail is included, more detailed information displays.
When only the command is entered (without any parameters included except detail), then all
dampened routes are listed.
When a parameter is specified, then the matching route or routes are listed.
When a decayed, history, or suppressed keyword is specified, only those types of dampened routes
are listed.
Parameters ip-prefix/mask — Displays damping information for the specified IP prefix and mask length.
ip-address — Displays damping entry for the best match route for the specified IP address.
damp-type — Displays damping type for the specified IP address.
decayed — Displays damping entries that are decayed but are not suppressed.
history — Displays damping entries that are withdrawn but have history.
suppressed — Displays damping entries suppressed because of route damping.
detail — Displays detailed information.
Output Show Damping Output Fields — The following table describes BGP damping output fields:
Label Description
BGP Router ID
The local BGP router ID.
AS
The configured autonomous system number.
Local AS
The configured or inherited local AS for the specified peer group. If not
configured, then it is the same value as the AS.
Network
Route IP prefix and mask length for the route.
Flag(s)
Legend:
Status codes: u- used, s-suppressed, h-history, d-decayed,
*-valid. If a * is not present, then the status is invalid.
Origin codes: i-IGP, e-EGP, ?-incomplete, >-best
Network
The IP prefix and mask length for the route.
From
The originator ID path attribute value.
Reuse time
The time when a suppressed route can be used again.
AS Path
The BGP AS path for the route.
To Next Page
Loading...
Need help?
General
