Alcatel-Lucent 7210 SAS M - Page 783

VPRN Show Commands
7210-SAS M Services Guide Page 783
Sample Output
*A:ALA-12# show router 3 interface summary
===============================================================================
Router Summary (Interfaces)
===============================================================================
Instance Router Name Interfaces Admin-Up Oper-Up
-------------------------------------------------------------------------------
1 Base 7 7 5
===============================================================================
*A:ALA-12#
route-table
Syntax route-table [ip-prefix [/mask] [longer] | [protocol protocol] | [summary]]
Context show>router
Description This command displays the active routes in the routing table.
If no command line arguments are specified, all routes are displayed, sorted by prefix.
Parameters ip-prefix[/mask] — Displays routes only matching the specified ip-prefix and optional mask.
longer — Displays routes matching the ip-prefix/mask and routes with longer masks.
protocol protocol — Displays routes learned from the specified protocol.
Values bgp, isis, local, ospf, rip, static, aggregate
summary — Displays a route table summary information.
Output Standard Show Route Table Output — The following table describes the standard output fields
for the route table.
Sample Output
Label Description
Dest Address
The route destination address and mask.
Next Hop
The next hop IP address for the route destination.
Type
Local — The route is a local route.
Remote — The route is a remote route.
Protocol
The protocol through which the route was learned.
Age
The route age in seconds for the route.
Metric
The route metric value for the route.
Pref
The route preference value for the route.
No. of Routes:
The number of routes displayed in the list.