Show, Clear, Debug Commands
Page 794 7210-SAS M Services Guide
protocol
Syntax protocol
Context clear>router>bgp
Description This command resets the entire BGP protocol. If the AS number was previously changed, the BGP
AS number does not inherit the new value.
id
Syntax id service-id
Context clear>service
clear>service>statistics
Description This command clears commands for a specific service.
Parameters service-id — The ID that uniquely identifies a service.
Values 1 — 2147483648
sap
Syntax sap sap-id {all | counters | stp}
Context clear>service>statistics
Description Clears SAP statistics for a SAP.
Parameters sap-id — Specifies the physical port identifier portion of the SAP definition. See Common CLI
Command Descriptions on page 939 for command syntax.
spoke-sdp
Syntax spoke-sdp sdp-id:vc-id ingress-vc-label
Context clear>service>id
Description This command clears and resets the spoke SDP bindings for the service.
Parameters sdp-id — The spoke SDP ID to be reset.
Values 1 — 17407
vc-id — The virtual circuit ID on the SDP ID to be reset.
Values 1 — 4294967295
To Next Page
Loading...
