Show, Clear, Debug Commands
Page 806 7210 SAS M Services Guide
Signal
Signaling
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on the SDP.
Last Status Change
Specifies the time of the most recent operating status change to this
SDP.
Last Mgmt Change
Specifies the time of the most recent management-initiated change to
this SDP.
Number of SDPs
Specifies the total number of SDPs displayed according to the criteria
specified.
Hello Time
Specifies how often the SDP echo request messages are transmitted on
this SDP.
Number of SDPs
Specifies the total number of SDPs displayed according to the criteria
specified.
Hello Time
Specifies how often the SDP echo request messages are transmitted on
this SDP.
Hello Msg Len
Specifies the length of the SDP echo request messages transmitted on
this SDP.
Hello Timeout
Specifies the number of seconds to wait for an SDP echo response
message before declaring a timeout.
Unmatched Replies
Specifies the number of SDP unmatched message replies.
Max Drop Count
Specifies the maximum number of consecutive SDP echo request mes-
sages that can be unacknowledged before the keepalive protocol
reports a fault.
Hold Down Time
Specifies the amount of time to wait before the keepalive operating sta-
tus is eligible to enter the alive state.
TX Hello Msgs
Specifies the number of SDP echo request messages transmitted since
the keepalive was administratively enabled or the counter was cleared.
Rx Hello Msgs
Specifies the number of SDP echo request messages received since the
keepalive was administratively enabled or the counter was cleared.
Associated LSP
List
When the SDP type is MPLS, a list of LSPs used to reach the far-end
router displays. All the LSPs in the list must terminate at the IP address
specified in the far end field.
If the SDP type is GRE, then the following message displays:
SDP Delivery Mechanism is not MPLS
Label Description (Continued)
To Next Page
Loading...
