VLL Show Commands
7210 SAS M Services Guide Page 811
service-using
Syntax service-using [cpipe] [sdp sdp-id] [b-vpls] [i-vpls] [m-vpls] [sdp sdp-id] [customer
customer-id]
Context show>service
Description This command displays the services matching certain usage properties.
If no optional parameters are specified, all services defined on the system are displayed.
Parameters [service] — Displays information for the specified service type.
b-vpls — Specifies the B-component instance of the Provider Backbone Bridging (PBB/IEEE
802.1ah) feature. It represents the multi-point tunneling component that multiplexes multiple
customer VPNs (ISIDs) together. It is similar to a regular VPLS instance that operates on the
backbone MAC addresses.
i-vpls — Specifies the I-component instance of the Provider Backbone Bridging (PBB/IEEE
802.1ah) feature. It identifies the specific VPN entity associated to a customer multipoint
(ELAN) service. It is similar to a regular VPLS instance that operates on the customer MAC
addresses.
m-vpls — Specifies the M-component (managed VPLS) instance of the Provider Backbone Bridging
(PBB/IEEE 802.1ah) feature.
sdp sdp-id — Displays only services bound to the specified SDP ID.
Default Services bound to any SDP ID.
Values 1 — 17407
customer customer-id — Displays services only associated with the specified customer ID.
Default Services associated with any customer.
Values 1 — 2147483647
Output Show service-using output — The following table describes the command output fields:
Label Description
Service Id
The service identifier.
Type
Specifies the service type configured for the service ID.
Adm
The desired state of the service.
Opr
The operating state of the service.
CustomerID
The ID of the customer who owns this service.
Last Mgmt Change
The date and time of the most recent management-initiated change to
this service.
To Next Page
Loading...
