Alcatel-Lucent 7210 SAS M Service Guide

Show, Clear, Debug Commands
Page 828 7210 SAS M Services Guide
base
Syntax base
Context show>service>id
Description Displays basic information about the service ID including service type, description, SAPs.
Output Show Service-ID Base — The following table describes show service-id base output fields:
Label Description
Service Id
The service identifier.
Vpn Id
Specifies the VPN ID assigned to the service.
Service Type
The type of service: Epipe, VPLS
Description
Generic information about the service.
Customer Id
The customer identifier.
Last Mgmt Change
The date and time of the most recent management-initiated change to
this customer.
Adm
The desired state of the service.
Oper
The operating state of the service.
Mtu
The largest frame size (in octets) that the service can handle.
Def. Mesh VC Id
This object is only valid in services that accept mesh SDP bindings. It
is used to validate the VC ID portion of each mesh SDP binding
defined in the service.
SAP Count
The number of SAPs defined on the service.
SDP Bind Count
The number of SDPs bound to the service.
Identifier
Specifies the service access (SAP) points.
Type
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received.
AdmMTU
Specifies the desired largest service frame size (in octets) that can be
transmitted through this SAP, without requiring the packet to be frag-
mented.
PBB Tunnel Point
Specifies the endpoint in the B-VPLS environment where the Epipe
terminates.
Admin MTU
Specifies the B-VPLS admin MTU.
Backbone-Flooding
Specifies whether or not the traffic is flooded in the B-VPLS for the
detination instead of unicast. If the backbone destination MAC is in the
B-VPLS FDB, then it will be unicast.

Alcatel-Lucent 7210 SAS M Specifications

General

Brand	Alcatel-Lucent
Model	7210 SAS M
Category	Switch
Language	English