VLL Show Commands
7210 SAS M Services Guide Page 841
Sample Output
A:Dut-A# show service id 1 sdp detail
===============================================================================
Services: Service Destination Points Details
===============================================================================
Sdp Id 1:1 -(10.20.1.2)
-------------------------------------------------------------------------------
Description : Default sdp description
SDP Id : 1:1 Type : Spoke
VC Type : Ether VC Tag : n/a
Admin Path MTU : 0 Oper Path MTU : 9186
Far End : 10.20.1.2 Delivery : MPLS
Admin State : Up Oper State : Up
Acct. Pol : None Collect Stats : Disabled
Ingress Label : 2048 Egress Label : 2048
Ingress Label
The label used by the far-end device to send packets to this device in
this service by this SDP.
Egress Label
The label used by this device to send packets to the far-end device in
this service by the SDP.
Last Changed
The date and time of the most recent change to the SDP.
Signaling
Specifies the signaling protocol used to obtain the ingress and egress
labels used in frames transmitted and received on this SDP.
Admin State
The administrative state of the Keepalive process.
Oper State
The operational state of the Keepalive process.
Hello Time
Transmission frequency of the SDP echo request messages.
Max Drop Count
Specifies the maximum number of consecutive SDP echo request mes-
sages that can be unacknowledged before the keepalive protocol
reports a fault.
Hello Msg Len
The length of the SDP echo request messages transmitted on this SDP.
Hold Down Time
Specifies the amount of time to wait before the keepalive operating sta-
tus is eligible to enter the alive state.
I. Fwd. Pkts.
Specifies the number of forwarded ingress packets.
I. Dro. Pkts
Specifies the number of dropped ingress packets.
E. Fwd. Pkts.
Specifies the number of forwarded egress packets.
Associated LSP
List
When the SDP type is MPLS, a list of LSPs used to reach the far-end
router displays. All the LSPs in the list must terminate at the IP address
specified in the Far End field.
If the SDP type is GRE, then the following message displays:
SDP delivery mechanism is not MPLS.
Label Description (Continued)
To Next Page
Loading...
