VLL Services
7705 SAR OS Services Guide Page 239
cpipe
Syntax [no] cpipe service-id [customer customer-id] [create] [vpn vpn-id] [vc-type {satop-e1 |
satop-t1 | cesopsn | cesopsn-cas}] [vc-switching]
Context config>service
Description This command configures a circuit emulation service utilizing MPLS or GRE encapsulation. The
vc-type defines the type of unstructured or structured circuit emulation service to be configured. All
other parameters (service-id, customer) have common usage with other service types.
Default no cpipe
Parameters service-id — uniquely identifies a service in the service domain. This ID must be unique to this
service and may not be used for any other service of any type. The service-id must be the same
number used for every 7705 SAR on which this service is defined.
Values 1 to 2147483647
customer-id — specifies the customer ID number to be associated with the service. This parameter is
required on service creation and optional for service editing or deleting.
Values 1 to 2147483647
create — keyword used to create a Cpipe. The create keyword requirement can be enabled/disabled
in the environment>create context.
vpn-id — specifies the VPN ID number that allows you to identify virtual private networks (VPNs) by
a VPN identification number. If this parameter is not specified, the VPN ID uses the same service
ID number.
Values 1 to 2147483647
Default null (0)
vc-type — specifies a value that defines the type of the VC signaled to the peer. This optional
parameter is included when the Cpipe service is created.
Values satop-e1: unstructured E1 circuit emulation service
satop-t1: unstructured DS1 circuit emulation service
cesopsn: basic structured n × 64 kb/s circuit emulation service
cesopsn-cas: structured n × 64 kb/s circuit emulation service with signaling
Default cesopsn
vc-switching — specifies that pseudowire switching signaling is used for the spoke SDPs configured
for this service
To Next Page
Loading...
