VLL Services Command Reference
Page 278 7705 SAR OS Services Guide
I. Fwd. Octs. Specifies the number of forwarded ingress octets
I. Dro. Octs. Specifies the number of dropped ingress octets
E. Fwd. Pkts. Specifies the number of forwarded egress packets
E. Fwd. Octets Specifies the number of forwarded egress octets
Eth-Cfm Configuration Information
Md-index Displays the value of the MD index
Direction Displays the direction of the MEP
Ma-index Displays the value of the MA index
Admin Displays the administrative state of the MEP (enabled or
disabled)
MepId Displays the MEP-ID
CCM-Enable Displays the status of the Continuity Check Message (CCM)
LowestDefectPri Displays a configured value that defects are evaluated against
HighestDefect Displays the highest defect
Defect Flags Indicates the defect flags
Mac Address Displays the MAC address (the MAC address for a spoke SDP
is the system MAC address; for a SAP, it is the port MAC
address)
CcmLtmPriority Displays the priority of the CCM Linktrace Message (LTM)
CcmTx Displays the number of CCM transmissions
CcmSequenceErr Displays the number of CCM sequence errors
DmrRepliesTx Displays the number of delay measurement replies transmitted
LmrRepliesTx Displays the number of loss measurement replies transmitted
Dual-Loss Test Displays the status of the dual-ended loss measurement test
(enabled or disabled)
Dual-Loss Thresh Displays the frame error threshold beyond which an alarm will
be raised. The threshold is expressed as a percentage.
Eth-Ais Displays the status of the ETH-AIS test (enabled or disabled)
Eth-Ais Rx Ais Indicates whether any ETH-AIS messages have been received
Table 34: Show Service-ID All Command Output Fields (Continued)
Label Description
To Next Page
Loading...
