VLL Services
7705 SAR OS Services Guide Page 279
Eth-Ais Tx Priorit* Displays the priority value of a transmitted ETH-AIS frame
Eth-Ais Rx Interv* Indicates the interval of a received ETH-AIS frame
Eth-Ais Tx Interva* Displays the interval of a transmitted ETH-AIS frame
Eth-Ais Tx Counte* Displays the number of ETH-AIS frames that have been sent
Eth-Ais Tx Levels Indicates the MD level of transmitted ETH-AIS frames
Eth-Tst Indicates the status of the ETH-Test (enabled or disabled)
LbRxReply Displays the number of received loopback (LB) replies
LbRxBadOrder Displays the number of LB replies that have been received in
the wrong order
LbRxBadMsdu Displays the number of LB replies that have been received
with the wrong destination MAC address (MSDU = MAC
Service Data Unit)
LbTxReply (Total) Displays the total number of LBRs (loopback replies)
transmitted from this MEP
LbTxReplyNoTLV Displays the number of LBRs (loopback replies) transmitted
from this MEP with no TLV
Note that because only LBMs with no TLVs are used for
throughput testing, the LbTxReply (Total),
LbTxReplyNoTLV, and LbTxReplyWithTLV counters can
help debug problems if throughput testing is not working
LbTxReplyWithTLV Displays the number of LBRs (loopback replies) transmitted
from this MEP with TLV
LbNextSequence Displays the sequence number of the next LB transmission
LtNextSequence Displays the sequence number of the next Linktrace (LT)
message transmitted
LtRxUnexplained Displays the number of the unexplained Linktrace (LT)
messages
Associated LSP LIST
Lsp Name Specifies the name of the static LSP
Admin State Specifies the administrative state of the associated LSP
Oper State Specifies the operational state of the associated LSP
Table 34: Show Service-ID All Command Output Fields (Continued)
Label Description
To Next Page
Loading...
