VLL Services Command Reference
Page 280 7705 SAR OS Services Guide
Time Since Last Tr* Specifies the time that the associated static LSP has been in
service
APIPE Service Destination Point specifics
Admin Concat Limit Specifies the administrative (configured) value for the
maximum number of cells for cell concatenation, as defined
via the max-cells command
Oper Concat Limit Specifies the operational value for the maximum number of
cells for cell concatenation
Peer Concat Limit Specifies the far-end value for the maximum number of cells
for cell concatenation
Max Concat Delay Specifies the amount of time to wait while cell concatenation is
occurring, as defined via the max-delay command
CPIPE Service Destination Point specifics
Local Bit-rate Specifies the number of DS0s used by the local SDP
Peer Bit-rate Specifies the number of DS0s used by the far-end SDP
Local Payload Size Specifies the local payload size, in bytes, used by the local
SDP
Peer Payload Size Specifies the peer payload size, in bytes, used by the far-end
SDP
Local Sig Pkts Specifies the type of signaling packets used by the local SDP
Peer Sig Pkts Specifies the type of signaling packets used by the far-end SDP
Local CAS Framing Specifies the type of CAS framing used by the local SDP
Peer CAS Framing Specifies the type of CAS framing used by the far-end SDP
Local RTP Header Specifies whether the local router inserts the RTP header
Peer RTP Header Specifies whether the peer router inserts the RTP header
Number of SDPs Specifies the number of SDPs bound to the service
IPIPE Service Destination Point specifics
Precedence Specifies the precedence level of the SDP binding
IpipeSdpBindCeIpAd* Specifies the IP address of the Ipipe spoke-sdp
Table 34: Show Service-ID All Command Output Fields (Continued)
Label Description
To Next Page
Loading...
