C613-50631-01 Rev A Command Reference for IE340 Series 1310
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
BGP AND BGP4+ COMMANDS
AGGREGATE
-ADDRESS
then the device will advertise the prefix 172.0.0.0/8, but no component routes
like 172.10.0.0/16
The as-set parameter controls the AS-path attribute that is advertised with the
aggregate route. If the device has learned multiple routes that are within the range
of the aggregate address/mask, and the AS-paths associated with those routes
contain different sets of AS-numbers, then it is not possible to create a single
AS-path that accurately represents the AS-paths of all those component routes. In
this case, the device will, by default, advertise a NULL AS-path with the aggregate.
Usage [BGP4+] If the summary-only parameter is specified, then only the aggregate
address/mask will be advertised, and none of the component addresses that fall
within the range of the aggregate address/mask. For example, if you configure:
then the device will advertise the prefix 2001:0db8::/64, but no component routes
like 2001:0db8:010d::1/128
Examples [BGP]
awplus# configure terminal
awplus(config)# router bgp 100
awplus(config-router)# aggregate-address 192.0.0.0/8 as-set
summary-only
awplus# configure terminal
awplus(config)# router bgp 100
awplus(config-router)# no aggregate-address 192.0.0.0/8 as-set
summary-only
awplus# configure terminal
awplus(config)# router bgp 100
awplus(config-router)# aggregate-address 172.0.0.0/8 summary-
only
awplus# configure terminal
awplus(config)# router bgp 100
awplus(config-router)#address-family ipv6
awplus(config-router-af)# aggregate-address 2001:0db8::/64
summary-only
To Next Page
Loading...
