C613-50631-01 Rev A Command Reference for IE340 Series 1610
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
ROUTE MAP COMMANDS
MATCH
IP ADDRESS
•If permit is specified, then the route is redistributed or controlled, as
specified by the set action.
•If deny is specified, then the route is not redistributed or controlled.
If the match criteria are not met, the route is neither accepted nor forwarded,
irrespective of permit or deny specifications.
This command is valid for:
•OSPF routes
• routes in BGP update messages
•RIP routes.
Examples To add entry 3 to the route map called ‘myroute’, which will process routes that
match the ACL called ‘List1’, use the commands:
awplus# configure terminal
awplus(config)# route-map myroute permit 3
awplus(config-route-map)# match ip address List1
To add entry 3 to the route map called ‘rmap1’, which will process routes that
match the prefix list called ‘mylist’, use the commands:
awplus# configure terminal
awplus(config)# route-map rmap1 permit 3
awplus(config-route-map)# match ip address prefix-list mylist
Related
commands
access-list (extended numbered)
access-list (standard numbered)
ip prefix-list
route-map
show ip access-list
show route-map
To Next Page
Loading...
