C613-50631-01 Rev A Command Reference for IE340 Series 2022
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
IPV4 SOFTWARE ACCESS CONTROL LIST (ACL) COMMANDS
(ACCESS-LIST EXTENDED IP PROTOCOL FILTER)
<destination> The destination address of the packets. You can specify a single
host, a subnet, or all destinations. The following are the valid
formats for specifying the destination:
<ip-addr>/
<prefix>
An IPv4 address, followed by a forward
slash, then the prefix length. This matches
any destination IP address within the
specified subnet.
any Matches any destination IP address.
log Log the results.
Table 39-6: IP protocol number and description
Protocol Number Protocol Description [RFC]
1 Internet Control Message [RFC792]
2 Internet Group Management [RFC1112]
3 Gateway-to-Gateway [RFC823]
4 IP in IP [RFC2003]
5 Stream [RFC1190] [RFC1819]
6 TCP (Transmission Control Protocol) [RFC793]
8 EGP (Exterior Gateway Protocol) [RFC888]
9 IGP (Interior Gateway Protocol) [IANA]
11 Network Voice Protocol [RFC741]
17 UDP (User Datagram Protocol) [RFC768]
20 Host monitoring [RFC869]
27 RDP (Reliable Data Protocol) [RFC908]
28 IRTP (Internet Reliable Transaction Protocol) [RFC938]
29 ISO-TP4 (ISO Transport Protocol Class 4) [RFC905]
30 Bulk Data Transfer Protocol [RFC969]
33 DCCP (Datagram Congestion Control Protocol)
[RFC4340]
48 DSR (Dynamic Source Routing Protocol) [RFC4728]
50 ESP (Encap Security Payload) [RFC2406]
51 AH (Authentication Header) [RFC2402]
54 NARP (NBMA Address Resolution Protocol) [RFC1735]
58 ICMP for IPv6 [RFC1883]
59 No Next Header for IPv6 [RFC1883]
Parameter Description
To Next Page
Loading...
