Allied Telesis IE340-20GP - Page 3255

C613-50631-01 Rev A Command Reference for IE340 Series 3255
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
LLDP COMMANDS
SHOW
LLDP INTERFACE
Related
commands
show lldp
show running-config lldp
Table 4: Parameters in the output of the show lldp interface command
Parameter Description
Port Port name.
Rx Whether reception of LLDP advertisements is enabled on
the port.
Tx Whether transmission of LLDP advertisements is enabled
on the port.
Notif Whether sending SNMP notification for LLDP is enabled on
the port:
• RM = Remote Tables Change Notification
•TP = LLDP-MED Topology Change Notification
Management Addr Management address advertised to neighbors.
Base TLVs Enabled
for Tx
List of optional Base TLVs enabled for transmission:
• Pd = Port Description
• Sn =System Name
• Sd = System Description
• Sc =System Capabilities
• Ma = Management Address
802.1 TLVs
Enabled for Tx
List of optional 802.1 TLVs enabled for transmission:
•Pv = Port VLAN ID
• Pp = Port And Protocol VLAN ID
•Vn = VLAN Name
• Pi =Protocol Identity
802.3 TLVs
Enabled for Tx
List of optional 802.3 TLVs enabled for transmission:
• Mp = MAC/PHY Configuration/Status
• Po = Power Via MDI (PoE)
• La = Link Aggregation
• Mf = Maximum Frame Size
MED TLVs Enabled
for Tx
List of optional LLDP-MED TLVs enabled for transmission:
• Mc = LLDP-MED Capabilities
•Np = Network Policy
• Lo = Location Information,
• Pe = Extended Power-Via-MDI
• In = Inventory