To remove a plug-in, go to Start Control Panel Add or remove programs. Select the plug-in file to be
removed and click on the Remove button.
The uninstall process takes about 1 minute.
2.3.3 HOW TO USE IT
To open the Configuration Tool, double click on the Conftool icon and wait while default Web browser is
opening.
To close the Configuration Tool, close the Web browser window.
2.3.4 WEB BROWSER CONFIGURATION
The Configuration Tool runs on a Web browser (Internet Explorer or Mozilla Firefox). Before using it for the
first time, it is necessary to configure some security parameters of the Web browser and the Flash Player. To
perform the configuration, follow these steps:
In the configuration tool window, right click and select Global Settings. The Adobe Flash Player Settings will
open;
Click on Trusted locations settings. The window will open;
Click on Add and then click on Browse for folder, find the RPV folder, then click it and after that click on the
OK button.
Close the Flash Player Help window.
2.3.5 RECEIVING EQUIPMENT CONFIGURATION
To be able to receive an equipment configuration, the user must be connected to the equipment by Ethernet
or modem interface.
Double click Conftool icon. The Configuration Tool interface will open in the default Web browser;
Click on the <RECEIVED> button. A new window will open;
Type IP address of the equipment and click on the <OK> button. An RPV-like configuration interface will
open. It is possible to check the configuration parameters as if user were on-line with the equipment;
Change the configuration if necessary;
Click on the <SAVE> button. A new window will open and require a name for this configuration. Type the
configuration name (maximum of 22 characters including , -, 0-9, a-z and A-Z);
Click on the <SAVE> button once again to save the new configuration on the PC;
Click on the <FINISH> button to go back to the main screen of the Configuration Tool.
The configuration will be on the list of locally stored configurations.
The configuration window will appear in the Configuration Tool. The user can choose to edit the configuration
again, store it or transmit it to the RPV.
It is possible to save the configuration with the same name as an existing one. However, the existing
configuration will be overwritten.
To Next Page
Loading...