Amazone GreenDrill GD200-E - 7.20.10 Calibrat. Button; 7.20.11 Systems of Units; 7.20.12 Factory Settings

GreenDrill control terminal 5.2
104
GreenDrill BAH0054-9 11.17
7.20.10 Calibrat. button
The GreenDrill has a calibration button (see section 7.6.3, page 74).
 Yes
 No
Change the parameters using the
buttons.
7.20.11 Systems of units
Display
 Metric system ................................... (m, ha, km/h, kg)
 Anglo-American system .................. (ft, ac, mph, lb)
Change the parameters using the
buttons.
7.20.12 Factory settings
 YES.......... The factory setting will be restored
 NO ........... The current settings will be maintained
Change the parameters using the
buttons.
When the factory settings are restored, the following data is main-
tained:
( The set language
( The total hours
( The total area.