Amazone GreenDrill GD200-E - Cleaning, Maintenance and Repair

General safety instructions
GreenDrill BAH0054-9 11.17
25
2.14.5 Cleaning, maintenance and repair
 Only carry out cleaning, maintenance and repair work on the implement when:
 the drive is switched off.
 the tractor engine is at a standstill.
 the ignition key has been removed.
 the implement plug has been disconnected from the control terminal.
 Regularly check the nuts and bolts for a firm seat and retighten them if necessary.
 Secure the raised implement or raised implement parts against unintentional lowering before per-
forming any cleaning, maintenance or repair work on the implement.
 When replacing work tools with blades, use suitable tools and gloves.
 Dispose of oils, greases and filters in the appropriate manner.
 Disconnect the cable to the tractor generator and battery before performing electrical welding
work on the tractor and mounted implements.
 Spare parts must at least comply with the specified technical requirements of AMAZONEN-
WERKE. This is ensured through the use of original AMAZONE spare parts.