GreenDrill control terminal 5.2
82
GreenDrill BAH0054-9 11.17
7.14 Turning at end of the field
Turning with position signal (working/transport position)
The turning procedure takes place automatically when the implement receives the following signals:
The implement is in working position
The implement is in transport position.
To do so, the implement must
be connected to the tractor socket (7-pin) or
have a working position sensor.
When turning, the seeding shaft is automatically switched off as soon as the implement is in transport
position. After turning, the seeding shaft is automatically switched on again as soon as the implement
is in working position. The blower fan is not switched off during the whole procedure.
Turning without position signal (working/transport position)
Turning without position signal (working/transport position):
1. Press the
button.
The green control lamp above the button is turned off
The seeding shaft stops
The blower fan continues to run.
2. Lift the carrying implement, turn, and move back to working position.
3. Start driving and press the
button.
The green control lamp above the button is illuminated.
The seeding shaft rotates at the nominal speed.
The seed is metered.
To Next Page
Loading...
