GreenDrill control terminal 5.2
GreenDrill BAH0054-9 11.17
75
7.7 Calibration (pulses/100 m)
The calculation requires the "pulses/100 m" calibration value
the travel speed [km/h].
the worked area [ha] (hectare counter).
the seeding shaft speed.
If the calibration value is not known, it must be determined by means of a "Pulses per 100 m" calibra-
tion run. The calibration value must be determined under operating conditions on the field.
If
the "Pulses per 100 m" calibration value is known, it can be entered manually.
the system has a GPS device, the "Pulses per 100 m" calibration value is not required.
Determine the calibration value
before initial use.
when changing from heavy to light soil and vice versa.
On different soils, the calibration value (pulses/100 m) can change due to
slippage of the measuring or drive wheel
a change in the number of pulses from the radar device.
if there are differences between the indicated and actual forward speed.
if there are differences between the measured and actual worked area.
To Next Page
Loading...
